HyLoft 00540 Instrucciones De Montaje página 2

Installation time approximately 30 minutes or less
Before beginning the unit installation , decide where it will work best for you above the open garage
door (if room allows) or beyond the open door.
PLEASE NOTE: If installing above the open garage door: at least 17" of open space is required
between the highest point of door as measured during its upward travel and the ceiling.
Locate the ceiling joists in the area of desired installation and determine the direction in which they are
running. In order to adequately disperse the stored load, you should not install more than two HyLoft
units on any two ceiling joists. The Ceiling Brackets are installed parallel to the ceiling joists. Refer to
the diagram below or photos on the package for additional installation clari cation.
IMPORTANT: Do not over tighten the lag screws (max 10 ft. lbs). They only need to be snug down,
no more. Do not use an impact driver.
Using Stud nder
Ceiling Joist
D
1B
Pre-drill 3/16" holes at pencil marks for each of the mounting points on the Support Bar Assemblies(C).
Rub some bar soap or add a drop of liquid soap to the threads of the lag screws to ease installation.
Using a Socket Wrench or Nut Driver, install one
Lag Screws(D) into each pre-drilled hole.
Repeat this process for installation of the remaining
parallel and in line to the rst one.
INSTALL ANGLE BRACKETS
locate Joists
24" to 36"
apart
Pencil mark
Mark holes on joist exactly
1A
Important Tip: There is a hole template
printed on the bottom of the carton. Cut out
the panel, punch out the holes and tape
to the ceiling to use for pencil mark locations.
Support Bar Assembly(C)using the 5/16" x 2 1/2"
Support Bar Assembly(C)
44.25" apart.
, being sure to install it