Andis DNG-1 Instrucciones De Uso página 4

19. The battery is to be disposed of safely.
20. Use only the charger supplied by the manufacturer to recharge.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE
OPERATING INSTRUCTIONS
Nail grinder must be pre-charged fully before using it for the first time. To start nail grinder,
push the POWER button; to stop, push the POWER button again. This nail grinder has
varying speeds. To increase speed, push the plus (+) button; to decrease speed, push the
minus (–) button (Figure A).
POWER SUPPLY
This unit is equipped with a universal AC/DC power adapter/battery charger (Figure A).
CHARGING NAIL GRINDER
The battery charger is intended for use with Andis DNG-1 nail grinder. Remove the nail
grinder and charger from the carton. Plug the charger into a 120V AC outlet, or according
to your local power standards (Figure A). Confirm the voltage available with each overseas
location before using the appliance. For connection to a 240V supply, use an attachment
plug adapter of the proper configuration for the power supply receptacle.
The nail grinder must be OFF before plugging the charger into the outlet and will not
operate while charging. Plug the adapter cord plug directly into the bottom of the nail
grinder (Figure A). The nail grinder has a lithium-ion battery that cannot be damaged by
overcharging. We recommend that the nail grinder be unplugged if not used for seven or
more days.
NAIL GRINDER INDICATOR LIGHTS
See the chart for charging status and corresponding indicator lights (Figure A). The nail
grinder will not turn on while being charged.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you know is
working).
2. Check to make sure adapter cord plug is plugged firmly into bottom of nail grinder. If
failure to charge still exists, return nail grinder to Andis or an Andis authorized service
station for examination and repair or replacement.
USING THE GRINDER ATTACHMENTS
(Attachments will vary by kit)
Your Andis nail grinder comes with different sizes of sanding drums and sanding bands
(Figure B). It is recommended to only use Andis attachments made specifically for this nail
grinder. Before changing any accessories, be sure that the nail grinder is turned off.
To remove a sanding drum: Press the collet release button while turning the collet nut
counter-clockwise until it locks into place. Using the wrench provided, turn the collet nut
until loose (Figure C). Remove sanding drum.
To insert a new sanding drum: Insert the sanding drum into the collet. Press the collet
4