How To Operate; Helpful Tips - Nostalgia Products TACO TUESDAY TTLJ3LG Instrucciones Y Recetas

ASSEMBLY
It is very important that the unit is assembled properly in order for the unit to work.
1. Place the pitcher on top of the base.
2. Place the pulp control filter on top of the pitcher with the fixed filter
nested on top of that. The filters should line up with the handle.
3. Make sure the extractor head is secured into the filter and the
juicing cone is placed on top of the extractor head.
4. The Salt/Sugar Rimmer, or Cover, may be placed on top to serve.
5. The margarita glasses come in two pieces - attach the
bottom of the margarita glasses onto the base.

HOW TO OPERATE

1. Before first use, remove all packaging materials
and assemble before plugging in.
2. Plug in the unit.
3. To start the Juicing process, place a citrus half on top of the
juicing cone to activate the juicer. NOTE: Press the fruit heavily
with hands to make the blades turn. It's also recommended to
place the other hand on the handle to keep the pitcher secure.
4. To control how much pulp gets filtered into the pitcher, slide
the switch on the handle (1-5 settings, 5 being the most).
5. When finished juicing, take off the extractor head
and juicing cone, along with the two filters.
6. Put in the ingredients to make your perfect margarita.
7. The Salt/Susgar Rimmer may be placed on top of the
pitcher or on a flat surface. Fill with salt or sugar.
8. Turn the glass upside down.
9. Dip all sides of the rim into the salt by lightly swirling the
glass. NOTE: It is recommended to wet the rim (or lip) of the
glasses with a fruit wedge to get the salt/sugar to stick.
10. Now you are ready to serve cold, refreshing margaritas
and drinks from your LIME JUICER & MARGARITA KIT!

HELPFUL TIPS

UNIT IS NOT TURNING ON
• If the unit is not turning on, make sure that it is fully and properly plugged into the outlet.
JUICER IS NOT WORKING
• Make sure that the juicing cone is placed on top of the extractor head.
Press the fruit heavily with hands to make the blades turn.
TOO MUCH/NOT ENOUGH PULP
• To control how much pulp gets filtered into the pitcher, slide the switch
on the handle. There are 5 settings (1-5), with 5 being the most pulp.
6