Adjusting The Weight; Resetting To Factory Settings - Titanwolf ADMIRAL Manual Del Usuario

Macros are recordings of specific key sequences, which can be run by pressing a
single mouse button depending on the configuration. This can, for example, be key-
strokes or mouse commands. To define a macro, please click on the desired button
and then select "Macro" from the list as described in section 5.2.1.
To start recording a new macro, first click on "New macro" and then specify
a name. Then the recording can be started using the "Start record" button and
stopped using the "Stop record" button. Additional options are available on the
right side of the Macro Manager for recording the steps. Thus you can define
whether the time between pressing the individual buttons and the stop times are
measured and recorded, or whether the recorded macro is executed several times
when the mouse button is pressed. The option of editing the individually recorded
steps subsequently or adding manually is also available. Use the menu item "Insert
event" for this purpose.
Note: Please remember the "Z" and "Y" are reversed. To configure, use the other
letter than the one desired to obtain the right result. Avoid umlauts and special
characters if possible.

6 Adjusting the weight

A cover, which is fixed to the bottom using a magnetic holder, is located on the
bottom of the mouse. The weights are located behind this cover. A total of four
weights each of 3.9g are provided.
Carefully lift the cover to remove it from the mouse. Now you can add or remove
weights to arrive at your preferred mouse weight. Before closing the cover, en-
sure that the weights are complete and placed straight inside the place holders,
to prevent any damage to the mouse. Ensure that the cover is correctly fixed back
to the mouse.

7 Resetting to factory settings

It is possible to reset the settings of the respective profile back to the factory set-
tings using the "Restore" button at the bottom of the software.
19
English