Retekess T-AC01 Manual Del Usuario página 5

Tamper alarm is the light sensor, a strong light changes will make alarm, it returned to normal
●
after 2 minutes.
For the first time using, please change the door open password and programming password
●
Pay attention to input or output the Wiegand interface mode, refer to the fifth setting
●
Data to copy the two host TXD and RXD to be cross-connected
●
When you copy the data, please pay attention to the difference of main and subordinate
●
machine, to avoid access machine data be emptied.
2. Fault analysis
Swipe card does not open the door:
Check whether the card is registered
●
Check the wiring if has some problems
●
if Access control mode is correct
●
Do not read the card:
Check the card type is correct or the card is damaged
●
Check whether the external card reader is placed too close to the machine
●
Tips:
* Please do not personally repair the machine, if you have any questions, please return to the
manufacturer for repair.
* Before installing on the wall, if you want to punch, please carefully check if there is the dark line
or line pipe to prevent drilling dark lines and other unnecessary trouble. Use safety glasses when
drilling or securing clamps.
* If the product is upgraded, the manual will change without prior notice.
Before using this radio, read this guide which cont-ains important operating instructions for safe
usage and RF energy awareness and control for compliance with applicable standards and
regulations.
This radio uses electromagnetic energy in the radio frequency (RF) spectrum to provide communications between
two or more users over a distance. RF energy, which when used improperly, can cause biological damage.
All Retekess radios are designed, manufactured, and tested to ensure they meet government-established RF
exposure levels. In addition, manufacturers also recommend specific operating instructions to users of the radios.
These instructions are important because they inform users about RF energy exposure and provide simple
procedures on how to control it.
Please refer to the following websites for more information on what RF
energy exposure is and how to control your exposure to assure compliance with established RF exposure limits:
http://www.who.int/en/
Local Government Regulations
When radios are used as a consequence of employment, the Local Government Regulations requires users to be
fully aware of and able to control their exposure to meet occupational requirements. Exposure awareness can be
facilitated by the use of a product label directing users to specific user awareness information. Your Retekess radio
has
a RF Exposure Product Label. Also, your Retekess user manual, or separate safety booklet includes information
and operating instructions required to control your RF exposure and to satisfy compliance requirements.
Radio License (if appropriate)
Governments keep the radios in classification, business radios operate on radio
frequencies that are regulated by the local radio management departments (FCC, ISED, OFCOM, ANFR, BFTK,
Bundesnetzagentur...).To transmit on these frequencies, you are required to have a license issued by them. The
detailed classification and the use of your radios, please contact the local government radio management
departments. Use of this radio outside the country where it was intended to be distributed is subject to government
regulations and may be prohibited.
Unauthorized modification and adjustment
Changes or modifications not expressly approved by the party respon-sible for compliance may void the user's
authority granted by the local government radio management departments to operate this radio and should not be
made. To comply with the corresponding requirements, transmitter adjustments should be made only by or under
the supervi-sion of a person certified as technically qualified to perform transmitter maintenance and repairs in the
RF ENERGY EXPOSURE AND PRODUCT SAFETY GUIDE
4