Milomex Z16531 Instrucciones De Utilización Y De Seguridad página 18

Operation / Cleaning and care / Disposal
(see Fig. F).
j Pull the rear part of the stapler gun upwards to
draw out the staple or nail from the workpiece.
Removing jammed staples
Q
from the stapler gun
Staples or nails may become jammed in the stapler
gun during operation. Remove jammed staples as
follows:
1. Press in the staple pusher
pull it downwards. Then pull the staple pusher
completely out of the magazine
2. Turn the stapler gun over so that the magazine
4 is pointing upwards.
3. Press the magazine
backwards and pull the magazine
(see Fig. E).
4. Now remove the jammed staples from the
magazine .
4
5. Press the magazine
backwards and press it downwards until it en-
gages to fix the magazine
Note: Do not use the stapler gun if it shows more
serious defects (damage to body etc.). If necessary
have your stapler repaired by a qualified specialist.
Take note that the manufacturer's original spare
parts only should be used in any repair.
Cleaning and care
Q
j The product must be kept clean, dry and free
of oil or lubricants at all times.
j Clean the product with a slightly dampened,
non-fluffing cloth.
GB/MT 16
16 GB/MT
slightly and then
2
.
4
4 at the side wings 5
4 upwards
at the side wings
4 5
back in place.
4
Disposal
Q
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
2