myFirst Drone Play! Manual De Instrucciones página 2

User Manual
READ BEFORE USING
When using this product, unexpected accidents such as injury to
others or damage to things may occur due to flying conditions or
steering errors. Be sure to read the included start guide and web
instruction manual carefully before using this product and strictly
observe the precautions.
Notes
• Avoid playing near glass, dark objects or a strong light source.
• Do not use the drone in areas with high wind speeds.
• Do not use the drone in a narrow or cluttered environment.
• Product to be used indoor. When using outdoor, the supervision
of adult is needed
• The recommended age to operate myFirst Drone is 6 years or
older.
• Children below the age of 6 must be supervised by a parent or an
adult.
• Do not fly near children under the age group.
• If the product is damaged due to an operational error, the repair
costs will be borne by the customer. Damage to the drone after a
flight is not covered by the warranty.
• Do not use operate the drone near fans or air conditioners. The
drone flight ability may be affected by the wind and may not fly
properly. Please close the windows before playing.
• Do not charge or store the device near an open flame, or in a hot
and humid environment. Avoid direct sunlight and keep out of
reach of children.
• Avoid disassembling, or putting in water or fire.
• We do not take any responsibility for any accidents caused by
failure to follow the notes and instructions.
Power on
Press and hold the 'Power'
button for 1 second to turn on the
drone. When the LED turns green,
it is ready to play.
Power off
Press and hold the 'Power' button for 2 seconds to turn off the drone.
The LED light should go off when the drone is off.
Charging the drone
It takes 40 minutes to fully charge the drone. During charging, the
LED light on the USB charger is turned on. When the battery is full,
the LED light on the USB charger will turn off.
A red LED on the drone indicates low battery.
Adjusting the speed
Make sure the drone is turned on. Press the 'Power' button to
toggle between normal and fast speed.
• Green LED light = Normal speed
• Blue LED light = Fast speed
Calibration
If your drone is flying abnormally, please calibrate the drone.
1. Turn the drone over and press the 'Power' button 3 times. The
LED light should begin flashing.
2. Quickly turn the drone back to its normal position and place it on
flat ground.
3. Drone calibration is complete when the LED light stays solid.
How to play
With the drone turned on, place the drone on the palm of an
extended arm. Lower your arm in a swift movement. The drone will
start flying automatically.
When the drone detects an object, it will move in the opposite
direction. Avoid playing near glass, dark objects or a strong light
source.
Note: The drone will ascend and hover in the air. When the drone's
proximity sensors are not activated for 2 seconds, it will
automatically descend to previous height.
To stop, grab the drone and flip it over as illustrated.
Designed in Singapore. Manufactured in China.
©2019 Oaxis Asia Pte Ltd. All Rights Reserved.
http://myfirst.tech