Maintenance And Cleaning; Technical Specifications - Mestra 100008 Manual De Instrucciones

INTRODUCTION
The Ref. 100008 is an electronic spatula for wax modelling with two heating heads, specially
designed to be used by professionals in the field of dental prosthesis. Its ergonomics, ease of
use, and small size make it an optimal tool for this type of work. The accuracy of the electronic
controls is also remarkable, since it maintains the temperature in the spatula head within a
narrow error range. The working temperature is shown on the digital display in the controls box.
The device is factory supplied wit six different heads and, therefore, it can be adapted to the
most common shapes used in the dental lab.
INSTALLATION
▪ Place the unit in a flat, horizontal and firm surface, away from vibration or heat sources.
Make sure there is not any flammable material nearby.
▪ Insert the jacks of the handles into the OUT1 and OUT2 outlets.
▪ Connect the unit to a grounded 230 V, 50/60 Hz power source.
OPERATION
▪ Select two of the interchangeable heads and fix them to the handles.
▪ Turn the main switch (C) on. The two displays will show the "oFF" message.
▪ Press the ( ) switch for the head you want to use. The head will warm up to the
temperature shown in the display, and the pilot light
▪ Press the (ºC/ºF) to shift to Celsius or Fahrenheit degrees.
▪ Press the (▼/▲) keys to change the temperature of the head.
▪ While you are not using any of the spatulas lean it on one of the magnetic holders (D).
▪ The heads may be placed in the holes of the casing (A).
▪ After finishing the operation, disconnect the wax heater by turning the main switch (C) off
and handle it cautiously for several minutes until it is cooled down completely.

MAINTENANCE AND CLEANING

To ensure a long life of the unit and an optimal operation, we strongly recommend:
▪ To clean the wax remains from the unit periodically. To do this you can use a small spatula.
Make sure the unit has been previously disconnected from the power source.
▪ Do not spill melted wax over the outer casing of the unit. Handle the spatulas with caution.

TECHNICAL SPECIFICATIONS

Voltage:
Power:
Fuse:
Temperature range:
Length x width x height:
Weight:
230 V, 50/60 Hz
20 W
2 A
50 ~ 200 ºC
122 ~ 392 ºF
120 x 150 x 70 mm
1.3 kg
will flicker.
English
7