Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
patterns.
DESCRIPTION OF MAIN PARTS
Fig.1
1.
Motor housing
3.
Lower handlebar
5.
Handlebar securing knob
7.
Switch lever
9.
Cable retainer
11. Deck
ASSEMBLY
Mounting the handlebar
1)
−
Put the cable hook on upper handle.(Fig.2)
−
Connect upper and lower handles with supplied screws and knobs. (Fig.3)
−
Insert the two lower handlebar tubes into the holes on main body. And fix it with lock
screw (15) (Fig.4.1-Fig.4.3))
−
Fix the cable holders(9) on handlebar.(Fig.5)
Fix the wheel
2)
−
Fit each wheels over the axles, secure in place with the pin and press the wheel covers
into place.(Fig.6)
Fitting the grass catcher
3)
−
Assemble two halves and fix them together.(Fig.7)
−
Lift the flap and place the grass box over the lugs. (Fig. 8)
OPERATION
Setting the cutting height (Fig. 9 & Fig.10)
NOTE: Stop, release switch lever and wait until the motor stops before adjusting
height, the blades continue to rotate for a few seconds after the machine is switched
off, a rotating blade can cause injury.
For the first cut of the season .a high cutting adjustment should be selected.
The cutting height can be selected among 25 mm, 40 mm , or 55 mm by adjusting the front
and rear wheels.
1. Front wheel adjustment (Fig. 9)
Pull the front wheel axle on either side of the mower deck in turn and relocated it in the
required position.
2.
Grass catcher
4.
Upper handlebar
6.
Safety button
8.
Rear deflector
10. Wheel
12. Cable clip
16
Publicidad
Tabla de contenido
