MoJack HDL 45501 Instrucciones De Ensamblaje Y De Manejo página 9

Ocultar thumbs Ver también para HDL 45501:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY AND OPERATING INSTRUCTIONS
STEP 8
To raise the mower:
Make sure the cylinder valve is closed by turning
the valve clockwise.
If yes, proceed to insert the handle into the cylin-
der handle opening.
Proceed to pump the handle up and down to raise
the lift to the desired height. The cylinder will use
pumping action of the handle to raise the lift.
The automatic locking mechanism will engage at
three different lift heights.
The 3 locking positions are: 18", 21", 26"
As you pump the handle to raise the lift you will
hear a click sound at each of the locking positions
indicating the locking bar is fully secured.
See below diagram of the locking bar function.
NOTE: Make sure your mower is in neutral before
you raise your mower. The mower wheels need to
move freely as the mower raises.
LOCKED
When Locking Bar
Cover is parallel with
the Locking Bar, the
Locking Pin is LOCKED
in the Bar teeth.
Locking Bar
The automatic locking mechanism must be engaged
in one of the three lock position notches on the
Locking Bar before proceeding to service mower.
Locking Bar
Cover
Locking Pin
NOT LOCKED
When Locking Bar
Cover is raised or
angled with the Locking
Bar, the Locking Pin is
NOT LOCKED in the Bar
teeth.
Locking Bar
Locking Bar
Cover
Locking Pin
9

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido