Cablematic MM021 Manual Del Usuario página 9

I
.lnstructlon before the operation
machine
A.
Connect the
Plug the power cord to the power supply of
◊
◊ Please note that the machi ne must be operated under the required voltage and
frequency.
◊ Please make sure that the operation desk is secure,durable and without inclination
B. The correct coW1ting way:
◊ Before starting to count the banknotes, please check whether there are
clips,staples, , e lastic bands or coins in the banknotes . . If there is, it may block the
machine.
Clips
◊
Do not put the deformed
Deformed
◊ Do not count ,vet,sticky or vezy dirty bi 11s.
◊
Please tidy up the banknotes on an even leve! to avoid jamming and errors.
◊ Set the position of the note guide to
be 2mm to 3mm longer than the
banknotes to be counted. Place the
banknote after twisting to fonn the
even slope.For the piled ban k note,
please loosen and pat it befare placn1g onto the sliding plate.Please
illustration, the Fig I is the right illustration for operation, and the Fig 2 and 3 are the
improper illustrations.
II
.Verifying and adjustment of the hopper plate
The hopper plate ensures proper feeding of the bilis for
counting.lt is secured to the back ofthe unit
of two pivoting points and a magnetic lock. To verify
that the hopper plate is properly adjusted press or lift
the hopper plate and look for any displacement(see the
figure).If any displacement occurs, press or lift the
hopper until the magnetic lock holds the piece in place.Adjust a proper gap bet,veen
hopper and feeding roller according to tuming the bill adjustment scre\V. Turn it left to
decrease the space and tum right to increase i
supply:
to the power
AC220V
Staptes Elastlc bands
folded and badly damaged banknotes on the feeding desk.
,.
Folded Broken
by
means
t.
+
60Hz.
10%,
Coins
X
check
the