Powering On/Off; Recording Videos; Taking Photos - Polaroid XS100i Manual Del Usuario

POLAROID XS100i USER GUIDE
3. To remove the Panel Cover, simply reverse the procedure in steps 1 and 2.
*Failure to properly seal your camera can result in leaks that may damage or destroy your camera. Your warranty does not
cover water damage resulting from user neglect.
*The rubber seal on the Panel Cover forms the waterproof barrier to protect the camera in wet and underwater
conditions. You must keep this seal clean; a single strand of hair or a single grain of sand can cause water to leak into the
camera.
*After every use in salt water, you will need to rinse the outside of the product and the seal with non-salt water, then dry.
Failure to rinse off salt water can cause corrosion within the camera and, in turn, damage will result.

Powering On/Off

To turn the camera ON:
1. Press and hold the Power Button
2. The camera will vibrate, and the Green LED will turn on.
To turn the camera OFF:
1. Press and hold the Power Button .
2. The camera will vibrate two seconds, and the Green LED will turn off.

Recording Videos

Before you start recording, select the video resolution by switching the Video Resolution Switch There are two HD
options to select from: HD (720p 60fps or 720p 30fps) and FHD (Full HD 1080p 30fps or 960p 30fps). You can change the
resolution by changing the settings with the XS100i software.
There are two methods available for starting the video record function. Recording is delayed 1-2 seconds as a short
vibration indicates recording has started. The LED indicator illuminates RED throughout the recording.
Method 1: Whether the camera power is ON or OFF , simply slide the Recording Slide Switchfrom STOP to REC to start
recording.
Method 2: When your camera is OFF and the Recording Slide Switch is at the REC location, press and hold the Power
Button to turn the camera ON, and it will start recording.
All manuals and user guides at all-guides.com
6
To stop recording, move the Recording Slide Switch from REC to STOP . The camera will vibrate and the LED Indicator
will illuminate GREEN to indicate the recording has stopped. The camera will then enter the Standby mode. An additional
option is to hold the Power Button to stop the recording and turn the camera off. The camera will vibrate two seconds,
and the Red LED light will turn off.
*A smaller video file of 432x240 (w/1080p/720p) or 320x240 (w/960p) will be created simultaneously when recording
an HD/FHD video file. The smaller video file size allows for more efficient uploading of content to social media sites and
email.
*Changing video resolution is disabled during video recording.
*Check that the MicroSD card has sufficient space to capture your video. The card is full when the camera vibrates for
5-seconds, and the Green LED
flashes continuously.

Taking Photos

The XS100i camera allows you to take 16MP , 5MP , 3MP , VGA high-quality still images.
To capture a still image
1. Turn on the camera by pressing the Power Button .
2. If the camera is in the video recording mode, move the Recording Slide Switch to STOP .
3. After the camera power has been turned on, press the Power Button to take a photo. A short vibration and a flash
of the Green LED indicate a still photo has been recorded.
*The still photo function is disabled during video recording.
*The default photo mode is "single photo." Burst mode gives you a series of 10 photo shots per second to capture that
"can't miss" moment. Time Lapse mode can be utilized to take a series of photos at 5, 10, 30 or 60-second intervals. To
change the mode, please refer to the section "Changing the camera settings"
*When the memory card becomes full, the camera will vibrate for five seconds and the Green LED will flash
continuously.
POLAROID XS100i USER GUIDE
7