Publicidad
Idiomas disponibles
Idiomas disponibles
Greenworks 80V Battery
Harness Carrying System
HOLSTER AND BATTERY INSTALLATION
1. Attach the holster to the waist belt.
2. Close the hook and eye fastener.
3. Insert battery into the holster.
4. Attach the strap to the velcro in the holster.
CONNECT BATTERY WITH PLUG
1. Insert plug into the side of the battery holster.
2. Push the plug into the connecting port until it stops.
Turn the plug clockwise until the latch engages.
3. Repeat the steps above to connect plug to the battery
adapter.
BATTERY HARNESS
1. Fasten and adjust the waist belt (1) so that it rests
comfortably on your hips – thread the end of the belt
through the loop (2) – do not let the strap hang down.
2. Adjust the harness straps (3) to the correct length.
3. Adjust chest strap (4) to correct length and fasten it.
HARNESS ADJUSTMENT
1. Pull the ends of the straps downward to tighten the
harness.
2. Lift the tabs of the adjusters to loosen the straps.
3. Close and lock the quick-release fastener by pushing
it together.
4. Squeeze the hooks to open the quick-release fastener.
CONNECT BATTERY ADAPTER TO TOOL
Insert the battery adapter into the tool. The adapter slides
into the battery compartment. Press down until it snaps
into position. The battery and the tool are now connected
together, and ready for use.
DISCONNECT BATTERY ADAPTER FROM TOOL
1. Turn power off to tool.
2. Depress latch (1) to unlock the battery adapter.
3. Remove battery adapter (2) from the tool.
GETTING STARTED
4
3
3
1
2
2
1
BH80A00
Publicidad
