ARDES ARM289 Instrucciones De Uso página 8

The appliance must be switched off while the comb is being attached or
removed.
The lever on the side of the hair trimmer has been specially positioned
near your thumb so that it can be easily used while holding the hair
trimmer.
This small lever makes the appliance more versatile, allowing you to
gradually change the length of the haircut without changing combs.
The blades produce the shortest cut when the lever is raised completely,
and the length is gradually increased as you press the lever downwards.
Furthermore, if the cut hair should jam the blades, you can remove the
hair be moving the lever instead of having to remove the blades.
While the appliance is still operating, move the lever up and down quickly
a few times. Performing this operation routinely at the end of each use
will help to keep the blades clean.
Maintenance
GB
After use, switch the appliance off and detach the plug.
Before cleaning the appliance, make certain that it has been switched off.
To clean the blades, use the small brushes supplied with the appliance or
disassemble the blades by loosening the appropriate screws.
Be careful to align the blades correctly when assembling them and
tighten the screws carefully.
To realign the blades, the teeth of the upper blade must be matched with
those of the lower blade point by point.
If the blades are misaligned, add a few drops of oil to the blades, switch
on the appliance for a few minutes, switch it off and disconnect it from the
socket. Remove the blades and reposition them.
The blades should be oiled at each haircut in order to keep the appliance
in good working condition.
Do not use hair oil, gel or oil mixed with paraffin or other solvents since
solvents evaporate and would leave the dense oil that could drip from the
moving blades.
Clean the equipment thoroughly after each use with a soft and slightly
damp cloth.
Never use abrasive products or chemical solvents.
Attention: keep dry the appliance.
NEVER DIP THE APPLIANCE INTO THE WATER.
8