Sensica Sensismooth Adapt 2U Manual Del Usuario página 6

Treatment
10 seconds
Cheeks
per side
Forehead 20 seconds
Nose & Chin 20 seconds
Pedicure
1. Clean and dry your skin.
2. Snap-on the pedicure pad
to the device adaptor.
3. Gently but firmly glide
the device continuously
over the treatment area.
4. Turn OFF, then clean
the used pad.
5. Sensismooth provides
visible results from the
first treatment. However,
in some cases reducing
tough skin may require
more than one treatment
session to see results.
6. Sensismooth should be
used when needed until
the required long-term
results are achieved.
6
7. Treat each area for 10-15
sec. A full treatment should
not exceed more than
five minutes, depending
on your skin condition.
• Holding the device
on a single spot may
lead to discomfort.
• For areas where the
skin is thicker or rougher,
use the edge of the
pad for better results.
8. After completing the
treatment, wipe or wash
the treated area.
• In order to ensure
effective treatment,
make sure to replace the
pad after completing
20 treatments.
• Sensismooth is pressure
sensitive. The device is
equipped with a safety
feature that stops it
from working if pressed
too hard on the skin.
Note: While the device
can be used as needed,
it is not recommended to
treat the same area more
than once a week.