Kenmore 116.36932 Manual Del Propietário página 9

Your Kenmore Vacuum features a two (2)
speed, direct drive agitator for cleaning a
variety of floor surfaces. Please review the
table below before using your vacuum.
Do not use the CARPET setting (high
speed) for cleaning berber style car-
pet. The high agitator speed could
damage the carpet or cause excessive
carpet wear.
2,
3.
Use the GENTLE setting (low speed)
ONLYfor berber or delicate pile car-
peting. The agitator may slow down or
stop on thick carpeting, area rugs or
throw rugs. If agitator stops and does
not restart, see page 12, AGITATOR
MOTOR OVERLOAD PROTECTOR.
The FLOOR setting may be used for
all indoor bare floors including wood,
tile, linoleum, slate etc.
Touch Control
Setting
Carpet (1)
Gentle {2)
Floor (3)
Agitator Bare
Speed Floor
High
Low
Off 7
To select a pile height setting:
Commercial
or Low Pile
€
Berber
or Delicate Area
Carpet Plush Shag Rug
€
Turn off vacuum cleaner. Select a pile
height setting by tilting the cleaner back
until front wheels are lifted slightly off the
floor.
Slide the adjustment lever to the correct
setting.
There are four (4) pile height settings on
the vacuum cleaner. Use the LOW setting
for most low-pile carpets and bare floor
cleaning (with agitator OFF), and the
HIGH setting for high-pile carpets like
shag carpet, scatter rugs, etc. Use the
other settings as needed for carpet
heights in between.
CAUTION
Do not allow vacuum cleaner to remain
in one spot for any length of time
when the agitator is turning. Damage
to carpet may occur,