SmartGyro Crosscity Manual De Instrucciones página 53

Always use the original charger provided with the product and connect it
correctly to the device (through the charging port) and to a power outlet. It is
important that you always use the charger that comes with your smartGyro,
otherwise, it may cause the device to fail and not be covered by the warranty.
Once the product has been loaded, it will take approximately two or three
hours to complete the charge.
When the LED light changes to green, it means that the product is fully
charged. It is important that at that time, immediately disconnect the adapter
from the network to stop charging. The battery life will be affected by the
battery charging time, never exceed and will extend the life of your battery.
Note that the approximate charging time is between 2-3 hours. Do not leave
the product charging once the adapter light has turned green or overcharge
the battery for more than 3 hours.
IMPORTANT:
A) The charge will be approximately 2-3 hours.
B) Do not overcharge the unit, since that will shorten the life of your battery.
Tips to keep in mind when loading
- Load preferably in locations away from flammable products.
- Monitor and control the charging period (which does not exceed the recommen-
ded).
- Use only the original charger. - Do not leave it charging at night.
- If it has been exposed to high temperatures, wait and check that it is not hot
before charging again.
- For the charging procedure it is important that it be turned off and that there is no
accessory connected, since if it is not possible for any of the sensors to be
activated and the battery will overheat.
Deutsch
Crosscity - Benutzerhandbuch
51 1
smartgyro.es smartgyro.es