Remote Controller
CAUTION: The Remote Controller will not function properly if strong
light strikes the sensor window of the air conditioner or if there are
obstacles between the Remote Controller and the air conditioner.
Power
• To turn the Set ON, push the button. To turn the Set OFF, push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the set is on the High cool mode and the temp. at 72°F
Temperature Setting
• This button control the room temperature setting in a range
between 60°F to 86°F in 1°F increments.
Fan Speed
• Pressing the Fan Speed button toggles between Low ,Mid and High
speeds.
On/Off Timer
- Stopping Operation
• Each press of the button cycles through the options in this
order:
1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours CANCLE.
• The set temperature will be raised by 2°F after 30 minutes and
again after another 30 minutes.
- Starting Operation
• Each press of the button cycles through the options in this
order:
1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours CANCLE.
Energy Saver
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
Cool/Fan/Dry
• Everytime you push this button, it will toggle between COOL, FAN, and DRY.
How to Insert Batteries
1. Remove the cover from the back of the remote
controller
2. Insert two batteries.
• Be sure of the polarity when installing the
batteries.
• Be sure that both batteries are new.
3. Re-attach the cover.
Operating Instructions
Power
Temp
Fan Speed
Timer
Mode
Energy
Auto
Saver
Swing
• Do not use rechargeable
batteries. Such batteries
differ from standard dry cells
in shape, dimensions, and
performance.
• Remove the batteries from
the remote controller if the air
conditioner is not going to be
used for an extended length
of time.
,
Owner s Manual 19