Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the right Bracket
4.
Align holes in rod assembly [C] with holes in panel and secure
with the following items from the hardware pack, Figure 5:
•
Two 1/4-20 x 1.75" screws [F]
•
Four flat washers [H]
•
Two 1/4-20 cap lock nuts [G]
InStallInG thE lEFt SIdE BraCkEt
remove the left Side hardware
5.
Remove the following from the left side of the upper handle,
Figure 6. The hardware removed can be discarded.
•
Two 1/4-20 screws
•
Two flat washers
•
Two 1/4-20 cap lock nuts
Installing the left Bracket
6.
Align holes in rod bracket [E] with holes in panel while placing end
of rod assembly [C] through the bracket. Secure with the following
items from the hardware pack, Figure 7:
•
Two 1/4-20 x 1.75" screws [F]
•
Four flat washers [H]
•
Two 1/4-20 cap lock nuts [G]
tIGhtEnInG thE handlE knoBS
7.
Tighten the four star knobs loosened in step 2.
ASSEMBLY AND OPERATION
C
H
G
F
H
Figure 5
Figure 6
E
H G
C
H
F
Figure 7
Publicidad
Tabla de contenido
