Slime 20321 Instrucciones De Montaje

BIKE STAND
Assembly Instructions
TOOLS REQUIRED
Adjustable Wrench, Allen Wrench (Included)
PARTS LIST
Square Tube (x 1)
Tubular Legs (x 2)
Wheel Supports (x 2)
Upright Tubes (x 4)
Cross Brace (x 1)
WARNING: Please read installation instructions carefully prior to installing.
Do not allow children to play on product. Slime is not responsible for any
damages resulting from improper installation, overloading or product failure.
LIMITED WARRANTY: These products are sold "as is" without any express or
implied warranties. Slime's sole liability, if any, shall be to replace this product
or refund the purchase price. The performance of these products is subject to
variable conditions and maximum load ratings are shown for comparison
purposes only.
ITW Global Tire Repair Inc. ITW AAMTech
125 Venture Drive, Suite 210 100 Hassall Street
San Luis Obispo, CA 93401 USA Wetherill Park, NSW 2164 Australia
WWW.SLIME.COM WWW.SLIME.COM.AU
MADE IN CHINA
The Slime Bike Stand has two different assembly options. Choose which you prefer before assembly.
OPTION 1:
Hex head Bolts (x 2)
OPTION 2:
Curved Washers (x 2)
Long Screws (x 6)
Short Screws (x 8)
Small and large
wheeled bike storage.
PART#20321 | 08.18.15
Store Bikes in SAME DIRECTION
DO NOT TIGHTEN SCREWS
UNTIL FULLY ASSEMBLED
Store Bikes in OPPOSITE DIRECTIONS
Assembly is same as Option 1,
but reverse direction of the
second set of Upright Tubes
and Wheel Support.
For better stability with smaller
wheels, back rear wheel into the
opposite side of stand.
INSTALLATION
Attach the two Tubular Legs to the Square Tube
using the Hex Head Bolts and Curved Washers
Insert two of the Upright Tubes into one of the
Tubular Legs and secure with two Short Screws
connect a Wheel Support to the opposite Tubular Leg
with two Short Screws. Use two Long Screws
upper portion of Upright Tubes to Wheel Support. Repeat
assembly above for the other half of the bike stand.
OPTION 1: OPTION 2:
SAME DIRECTION OPPOSITE DIRECTIONS
Connect the Wheel Supports together with the Cross
Brace using two Long Screws.
OPTION 1: OPTION 2:
SAME DIRECTION OPPOSITE DIRECTIONS
.
. Then
to attach