Typical Installation - Porter Cable PXCM010-0012 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Key Description

Air hose

In-line Filter

Tee Fitting

Spray Gun Setup

This spray gun is designed for use as a "bleeder type",

which means that air will continuously pass through the

gun without pulling the trigger. Paint or the material being

sprayed is added to the air stream by pulling the trigger.

Depending on which of the supplied air caps is installed,

this spray gun will provide External Mix/Pressure Feed or

Internal Mix/Pressure Feed.

For use as External Mix Pressure Feed:

1. Install the external mix air cap (10) onto the end of the

spray gun.

NOTE: This set up is used when spraying medium

bodied, fast-drying materials such as lacquers and

fast-drying enamels.

For use as Internal Mix Pressure Feed:

1. Install the internal mix air cap (9) onto the end of the

spray gun.

NOTE: This set up is used when spraying relatively thick, slow-drying materials

such as latex or oil based paints.

Spraying Instructions

1. As a standard practice, drain water from the air compressor tank and air lines

prior to use each day (reference your compressor operators manual for detailed

instructions). NOTE: Failure to install appropriate water/oil removal

equipment may result in damage to the spray gun or workpiece (see Figure

A).

2. Install a 1/4" NPT female plug (not included) onto the air inlet port on

the tool (see Figure B). Note: Use Teflon

connections.

3. Mix material according to the manufacutrer's instructions, adding thinner if

needed. Mixture should be smooth and easily pourable. Lumps or foreign

objects should be removed by straining through a suitable paint filter or

cheesecloth.

4. Fill the cup no more than 3/4 full. Firmly attach the cup to prevent air leakage.

Avoid damage to the sealing surface of the cup and the gasket. Damage to

these parts will cause air leaks and prevent the gun from spraying properly. If

paint leaks around the needle pin packing gland, tighten the packing gland

nut just enough to stop the leak but not enough to interfere with movement of

the needle pin. Apply light machine oil to keep the packing soft and help

avoid leaks.

5. Attach air supply line to 1/4 NPT female plug.

6. Start the compressor and set the regulator to 25-50 PSI. NOTE: Be sure there

is sufficient hose connected between the gun and air supply to comfortably reach the work surface.