Accutire MS-4021 Guia De Inicio Rapido

Specifications
Range: 5-150 PSI
Operating Temperature: 14°F~122°F
(-10°C~50°C)
Accuracy: +/- 1% + 0.5 PSI
Power: Replaceable Alkaline LR44 1.5V Coin
Cell (3)
Instructions
1. Remove battery tab before 1st use. Pull tab
to remove, gauge is now ready for use.
2. Push nozzle of Accutire on to tire valve.
Make sure a good seal is made between the
nozzle and valve stem so that no hissing
sound of escaping air is heard.
3. Hold gauge on valve stem until the reading
locks on the dispaly.
4. Promptly remove gauge from valve stem and
read pressure. You may continue to use the
gauge even though the previous reading is
still displayed by following the instructions
above.
Note: The gauge will shut off automatically.
5. Check your tire gauge once a week,
estimate the battery life is 1 year based on 5
operations per day.
Zero Set
The gauge is a precision electronic instrument
and from time to time it is advisable to check
the zero setting especially at extreme hot or
cold temperatures. To check the zero setting:
Briefly press the gauge onto the tire valve. It is
not necessary for a good seal to be made. Only
a small amount of air must enter the gauge to
zero set the unit. Promptly remove gauge from
valve stem when display shows "00.0". Your
Accutire has now been recalibrated.
Replacing the Batteries
To replace the batteries, unscrew the battery
cover and remove the old batteries. Insert new
batteries (Maxell LR44 or equivalent), being
careful to observe the correct polarity. Replace
the battery compartment cover and screw
tightly.
Battery notes
1. Batteries included.
2. Do not mix old and new batteries.
3. Do not mix Alkaline, standard (carbon-zinc)
or rechargeable (Nickel cadmium) batteries.
4. Do not dispose of batteries in fire. Batteries
may explode or leak.
What to do if
1. You do not get any reading at all (either
blank display or all zeros). Please reinstall
the batteries and see the instructions and
follow them carefully. If gauge still does not
work, see Warranty and Service section.
2. You observe "Lo" on the display. The power
supply has been depleted. Pls replace
batteries
3. You observe an unusally high or low
reading. Make sure no sound of escaping air
is heard, as in Step 1 of the instructions.
Also, make sure you are checking the
pressure on cool tires which have not been
driven on for several hours.
Tire pressure advice and actions
• Always be sure to follow vehicle
manufacturers recommended tire pressure
ratings which are based on cool tire
temperatures.
• The electronic module and power cell are
factory sealed in the unit. There are no user
serviceable parts.
• To clean the gauge, use a soft damp cloth.
Do not immerse in, or spray with water or
other liquid cleaner.
Warning
This product contains lead, a chemical known
to the State of California to cause birth defects
and other reproductive harm.
Warranty and Service
Measurement Ltd., Inc warrants this gauge
against defects in material or workmanship for
a period of five (5) years from the date of
purchase and agrees to replace it free of
charge. This warranty does not cover damage
resulting from misuse or abuse of the product.
Should your gauge require service, you may
send it back to Measurement Ltd., Inc for
repair or replacement.
Our authorized service center
address is:
Measurement Ltd., Inc.
11751 Rock Landing Drive, Suite H-7, Newport
News, VA 23606
Attn: Customer Service
Tel : 757-706-3839
US Patent No.D409931
Made in China