USING YOUR EUROSTEAM
IRON
®
®
Water in your boiler? This is normal as each Eurosteam
Stone Glide is
factory tested for quality purposes .
TO
START
ensure that your Eurosteam® iron is in optimal working order. You will only need
your boiler tank. Screw on your safety cap with your cap remover. Plug unit in, and wait for
ready light to turn off. Direct the iron in a safe direction, then hold down the steam button
and continue holding the steam button to allow the full tank of steam to run out of iron. When
completed let unit cool completely.
® ironing.
1. Water
The Eurosteam® Iron is designed to use regular tap water. Never use 100% distilled water
as this may lead to damage inside the boiler.
About Softened Water and Well Water
Many types of water contain naturally high levels of sodium, iron, mineral and organic mat-
ter. If these collect inside the boiler it can eventually appear as brown stains or can cause
Never use water that has any additives such as starch, perfume or fabric conditioner. The
additives can affect the boiler, at high temperatures deposits can form and emit stains and
cause blockage of the steam vents.
2. Filling internal Water/Boiler Tank
Fill water tank while the Eurosteam® is unplugged and cool. Place your iron on a stable sur-
boiler. Place safety cap in position and tightened, by turning until it stops and then tighten
slightly without applying too much pressure to avoid breaking the O-ring. Plug the unit into a
power surge bar. Put the iron in a vertical position, if not on an ironing board iron holder or
heat resistant mat and wait for the indicator light to shut off.
At the end of every use be sure to drain the boiler by letting all steam out. Hold down the
steam button and wait until steaming has stopped, unplug and wait for unit to cool. Remove
safety cap using the provided cap remover and hold upside down to drain any remaining
water. Store in a safe place with safety cap off, allowing the boiler to breathe.
5
®
USING YOUR EUROSTEAM