Specifications - RocketFish RF-700WPS Guía Del Usario

Remove the old power supply from your computer case and install your
5
new Rocketfish power supply.
Connect the 24-pin Main Power Connector to your motherboard.
6
Note:
Use 24-pin to 20-pin adaptor if your motherboard requires 20-pin power connector.
Connect the Serial ATA connectors to the peripheral devices.
7
Connect the peripheral 4-pin power connectors if you are still using an
8
IDE connector for hard drives or a DVD/CD drive.
Connect the PCI Express power connector to your PCI Express graphics
9
cards, as needed.
Connect your case fans to the regular 4-pin peripheral connectors if you
10
are using these fans.
Caution:
Make sure that all connectors are correctly connected. Incorrect connection could
prevent your computer from booting and some components might even be
damaged.
Close your computer case and connect the AC power cord to the power
11
supply.
Booting your system
To boot your system:
Turn on the power supply by setting the I/O switch on the power supply
1
to the "I" position.
Turn on your computer by pushing the power button on the front of
2
your system.

Specifications

Input
Voltage
Frequency
Current
4
USA, Japan, and others: 115 Vac
Europe, South East Asia, and others: 230 Vac
60 Hz-50 Hz
10 A (max.) at 115 Vac/60 Hz
7 A (max.) at 230 Vac/50 Hz