Telstar TFA004910MD Manual De Instrucciones página 13

AIR FRYER
TFA004910MD
the ingredients, pull the pan out of the appliance by the handle and shake it. Then slide the pan back into the
air fryer and continue to cook.
7. When you hear the timer bell, the set preparation time has elapsed. Pull the pan out of the appliance and
place it on a heat-resistant surface.
Tip: To reduce the weight, you can remove the basket from the pan and shake the basket only. To do so, pull
the pan out of the appliance, place it on a heat-resistant surface and press the button of the handle.
Tip: If you set the timer to half the preparation time, your timer will ring when you have to shake the ingredients.
However, this means that you have to set the timer again to the remaining preparation time after shaking.
(See settings)
Tip: If you set the timer to full preparation time, there is no timer bell during cooking before finishing, you can pull
out the pan at any time to check the ingredients cooking condition. The power will shut down automatically
and, will only resume after you slide the pan back into the appliance (timer always counts down in this situation).
Note: You can also switch off the appliance manually. To do this, turn the temperature control knob to 0, or
simply pull out the pan.
8. Check if the ingredients are ready. If the ingredients are not ready yet, simply slide the pan back into the
appliance and set the timer to a few extra minutes.
9. To remove small ingredients (e.g. fries), put the pan on a flat heat resistant surface, and press the basket
release button and lift the basket out of the pan.
10. Do not turn the basket upside down with the pan still attached to it, as any excess oil that has collected on
the bottom of the pan will leak onto the ingredients.
11. After hot air frying, the pan and the ingredients are hot - avoid touching. Depending on the type of the
ingredients in the air fryer, steam may escape from the pan.
12. Empty the basket into a bowl or onto a plate.
13