ePropulsion CH4200 Manual página 2

Introduction
The E battery charger is a product designed for the E-Series Battery. It has: wide input voltage range,
universal voltage; small interference to other electrical equipment; designed in accordance with IP66
protection level, high waterproof performance; can be used in parallel; quiet work, high reliability, simple
installation, operation, and maintenance.
Specifications
Model
Input voltage
Input current
Power factor
Rated output voltage
Output current
Parallel connection
Conversion efficiency
Protection level
Operation temperature
Storage temperature
Certification
In the Box
Charger
User manual
Communication cable
Operation
1.
Ensure the power has been
switched off, and complete the
wiring according to the figure.
2.
Turn on the battery power
button first, then turn on the
AC switch.
3.
The green light of the charger
flashes, indicating that the
charger is charging normally.
*For the DC output cable, red is
positive, black is negative.
CH4200
85~265 VAC
<9 A @220 VAC
<12 A @110 VAC
≥0.99
48 VDC
30 A @220 VAC
~20 A @110 VAC
8 (Max)
≥93%
IP66
-25 °C ~ 55 °C
-40 °C ~ 85 °C
CE
1 set
1 piece
1 piece
Charge the battery by one charger:
AC
input
cable
LED Indicator
Flashing green light
Steady green light
Flashing red light
Green and red lights
flash alternately
Other
Y type communication cable
AC input cable
DC output cable
DC
output
cable
Communication cable
Charging
Charging stopped / fully
charged
Failed to communicate
with the battery
No battery connected
Charger error, please
restart the charger, if the
problem persists, please
contact ePropulsion
authorized dealer
1 piece
1 piece
1 piece
E-Series Battery