Maintenance And Cleaning - Mestra 080620 Manual De Instrucciones

Tank for distilled water
Ref. 080620 is a tank specially designed for the
storage and supply of distilled water under
pressure in the dental sector.
Before filling the tank
Before filling the rank, it must be properly
cleaned and sterilized. Do not use detergents
containing hydrochloric acid, hypochlorous acid,
etc.
Installation
For correct use of the appliance, we recommend
that you adhere to the following instructions:
 Carefully unpack the appliance.
 Place the tank away from heat sources.
 Check that it has not suffered any damage
during transport.
 Check that the tank is not scratched or dented.
 Close the input and output valves (B and E).
 Connect pressurized air to inlet connector (B).
 Connect the power tube for your equipment to
the outlet connector (E).
 Open the lid and fill the tank with water.
 Close the lid.
 Open the pressurized air inlet cock (A).
 Use the regulator (D) to adjust the pressure
(below 5 bar).
 Open the water outlet tap (E).
Filling
 To open the tank, first close the inlet and outlet
valves (B and E).
 Then, pull the ring of the opening valve (A) to
depressurize the tank.
 Now you can open the lid and fill the tank.
 Close the lid.
 Open the inlet and outlet valves (B and E).

Maintenance and cleaning

To ensure correct, reliable, and enduring
operation, we recommend:
 Use the tank with care.
 Avoid falls, bumps and inappropriate
movements of the tank; they could cause it to
malfunction.
 Do not use if the tank is damaged, scratched or
dented.
 Do not use if the cover is dented or bent.
 The cover and connections must always be
kept clean and free of any contaminating
agent.
 The life of the lid's O-ring depends on the use of
the tank, the storage location and the
environmental conditions. It is recommended
that this component be replaced at least once a
year.
 The tank should be located away from heat
sources.
Características técnicas
Height: ....................................................... 680 mm
Width with pressure regulator: .................. 255 mm
Diameter: ................................................... 225 mm
Weight: ......................................................... 4,7 kg
Max. pressure: ................................................ 5 bar
Tank material: ............................ Stainless steel 304
Capacity: .................................................... 18 litres
Operation temperature: .......... 0 - 45 ºC (32 - 45 ºF)
Declaration of conformity UE
The firm Talleres Mestraitua S.L.
with social address: Txori-erri Etorbidea, 60
48150 Sondika - Bilbao - Spain
Hereby declares that the product
Tank for distilled water Ref. 080620
cumple con los requisitos de las siguientes directivas:
Meets the requirements set out in the directive:
2014/68/CE (pressure equipment)
EN

Ignacio Mestraitua
Managing Director
Sondika, 2021-02-15