Levolor App Overview; Getting Started; Battery Placement; Tools Needed To Mount Remote Holder - Springs Window Fashions Levolor Manual De Instrucciones

LEVOLOR App Overview
®
LEVOLOR APP OVERVIEW
®
Unlock your shades' full potential; download the LEVOLOR
App for advanced controls and easy 3 Step Set-Up Guide.
Easily organize and control all of your motorized LEVOLOR
products by pairing your remote(s) to the LEVOLOR App.
The app's advanced controls allow you to adjust your window
coverings, create favorite preset positions, and program your
shades to run automatically on a timed schedule.
Download the app to your mobile device from the Google
Play or Apple App Store. The LEVOLOR App is compatible
with Android (version 5.1 or newer) and Apple iOS (version
11.0 or newer).
The app is powered by Bluetooth connectivity, which allows
your iOS and Android devices to control your window coverings
wirelessly over short distances. Both your mobile device and
remote must be within range of your window covering(s) in
order to control them using the app and to create or edit a
preset schedule or Favorite.
NOTE: Your mobile device ONLY needs to be within range
of the remote and the window covering in order to create or
edit a schedule. The window covering will then automatically
run according to the programmed schedule regardless of
the location of your mobile device as long as the remote is
within range.
6
Remote Control Guide

BATTERY PLACEMENT

1. Remove the back cover, to expose the battery
compartment.
2. Use two new AAA Alkaline batteries (provided).
Slide a battery into each compartment being
sure to align correct positive and negative ends
and press into place.
3. Replace the back cover.

TOOLS NEEDED TO MOUNT REMOTE HOLDER

— Power drill
— Phillips screwdriver
— Drywall anchors, if mounted into drywall (not provided).

MOUNTING INSTRUCTIONS

1. Choose a location to mount the remote holder.
2. Orient the remote holder on the wall. Mark
screw holes.
3. If you are mounting the remote holder onto wood,
use a ⁄ " drill bit to drill the screw holes.
3
32
4. Attach the remote holder to the wall using the
screw provided.
5. Snap screw cover over screw.
6. Gently push the remote into the remote holder
until it is snug.
NOTE: If you are mounting the Remote Holder onto
drywall, use drywall anchors.

Getting Started

— ⁄ " drill bit
3
32
— Pencil
Curved edge
should be
on top
Remote Control Guide
7