EN
scale by pushing the MENU- button.
When the number of the correct scale is
displayed, keep waiting. You will see run
on the display and in a moment the meter
will go off. Now the meter is ready for use.
3.3. Measurement step by step
Filling the measuring cup
Place half a handful of sawdust taken with
a motor chain saw, pellets or usual
sawdust at the bottom of the measuring
cup and shake the meter. Then fill the
measuring cup (for sawdust fill the cup to
the brim) and twist the cap until the center
of the cap is on the same level with the
cap's surface. Now the compression of the
sample is good enough (see pictures in
the appendix).
Measurement
Before carrying out the measurement
mix the collected sample properly .
Switch on the meter with a single press on
the ON/OFF-button.
The number of the selected scale will
appear on the display. After that the meter
proceeds to the measurement. You will
see run on the display during the
measurement. The result of the
measurement (moisture content) will be
displayed in weight percent. After the
measurement the meter will automatically
go off and will be ready for a new
measurement.
You can ensure that the measurement