Getting Started - Design & Drill Marble Maze Guía De Iniciación

Getting Started

1. Insert three (3) AAA batteries into the
drill's battery compartment following
the instructions in this guide.
2. Help your child install the drill bit onto
the end of the drill.
3. Show your child how to change the
direction of the drill bit by sliding the
button on the back of the drill.
4. Lay the board flat and demonstrate to
your child how to drill the bolt in, and
then reverse the drill to show how to
remove the bolt.
4
5. Place a track piece on the board.
Next, place a bolt in the slot to secure
the track and drill it in fully. Some track
pieces have a long slot to allow the
piece to slide side to side. This allows
for maximum creativity.
6. Let your child experiment with placing
pieces and watching how the ball
moves through them. As they place, tilt,
and adjust pieces, they are learning
important problem solving, cause and
effect, and spatial awareness skills!