Broan 8770 Instrucciones De Instalación

MODEL: 8770, 8772, 8778
RECESSED / SURFACE
MOUNTED STEEL MEDICINE
CABINETS
MIRROR CARE
•
Use only clean warm water and a clean,
soft, lint-free cloth.
•
DO NOT USE cleaners that contain
solutions of ammonia, vinegar, or chlorine.
•
DO NOT USE powdered cleansers or steel
wool.
•
Never spray cleaning agent directly on
mirror, especially on exposed edges and
mirror backing. Apply cleaner to soft cloth
and wipe mirror. Dry mirror thoroughly.
•
Keep mirror dry. A well ventilated bath
room is important.
INSTALLATION of RECESSED MOUNTED CABINET
1. Carefully remove all packing material. Place shelves and
hardware package aside until needed.
2. Determine desired location of cabinet on wall. Mark wall
to show wall opening size (see dimension chart).
Generally, the recommended height to the center of the
cabinet is 64" from the floor. (Fig. 2).
3. CAUTION: Wall studs, plumbing or electrical lines that
interfere must be removed or relocated. Cut wall opening,
being careful not to damage the surrounding wall surface.
Insert framing to support all plaster board edges.
4. Insert cabinet into wall opening in plumb and centered
position. Use a carpenter's level and shim corners of
cabinet if necessary. Secure to wall studs through the 4
mounting holes inside cabinet (screws provided) (Fig. 3-A).
5. Place shelf brackets at desired heights. Place shelves on
brackets. (Fig. 3-B).
Fig. 3
B
A
For help, call us
toll free!
1-800-637-1453
To register this product, visit www.broan.com
INSTALLATION INSTRUCTIONS
MODEL OVERALL SIZE
NO. W
8770 16 1
1
8772 16
8778 16 1
INSTALLATION of SURFACE MOUNTED CABINET
1. Carefully remove all packing materials. Place shelves
and hardware package aside until needed.
2. Position cabinet on wall and mark wall through holes
(Fig. 1-A) in back of cabinet. NOTE: The commonly
accepted height of a medicine cabinet is 64" from the
finished floor to the center of mirror area. However, adjust
to comfortable height for your family.
3. Draw a horizontal line connecting the two marks (Fig. 1-A).
This line must be level and, if necessary, should be
adjusted by using a carpenter's level.
4. Insert mounting screws (provided) through the holes in
back of the cabinet (Fig.1-A). If studs are not available,
use 3 / " wall anchors (not provided) depending on wall
16
material.
5. Insert mounting screws through bottom mounting holes
(Fig. 1-B).
6. Place shelves on shelf brackets at desired heights.
Fig. 1
A
Fig. 2
Approx.
64" to
Floor
WALL OPENING
H D W H
/ 24 1 / -- 14 18 3
4 4
1 1
/ 24 / 5 / -- --
4 4 2
/ 26 1 / -- 14 24 3
4 4
D
1 /
2
--
1 /
2