ARDES phobos 840 Folleto De Instrucciones página 13

INSTRUCTIONS FOR USE
The humidifier is provided with a special safety system which prevents the
boiler from being separated from the water reservoir when the power supply
cable is plugged into the appliance.
Fig. 1 In order to separate the boiler from the reservoir, first disconnect the
power supply cable (1) and then twist the boiler counter-clockwise (2)
and lift it off (3).
For tap water into the reservoir until the coloured mark on the float
appears.
Do not add salt or any other substances into the reservoir to avoid
damaging the appliance and causing safety problems.
Fig. 2 Fit the boiler onto the tank with the arrow onto the plastic cover
corresponding to the arrow on the tank's band (1) and then twist it
clockwise as far as it will go (2).
Now plug the power cable into the humidifier (3).
It is necessary to await 5/10 minutes before the appliance gets the
maximum intensity of vaporization.
Fig. 3 Before plugging the power cable into the humidifier, make sure that the
appliance has not become wet during filling. Otherwise, dry it carefully.
If you want to use scented oil, you must pour it into the small recess
around the steam outlet hole (fig. 3) before plugging the power supply
cable into the appliance.
In order to start up the appliance, plug the power supply cable into the
wall socket. It will take a few minutes before it starts emitting steam.
Fig. 4 The steam jet can be adjusted by means of the adjusting knob (fig. 4).
If the water level drops below the level of the electrodes, steaming
stops. This does not damage the appliance and does not consume
power.
A residual amount of water with all the impurities will remain at the
bottom of the reservoir. It will serve to make cleaning easier.
When using again the humidifier after a pause, first empty it and rinse it out
well before pouring in fresh tap water. If you don't, the water's conductivity is
increased and this makes the appliance becomes noisy and the electrodes
wear out more rapidly.