Listening To Stored Stations - Aiwa RMD-99 ST Manual De Usuario

14
en
USING THE STORED STATIONS
There's a total of 550 preset memories within the unit. 100 preset memories for each
FM, MW, and LW band, and 250 for SW.
METHOD 1: ATS (AUTO TUNING STORAGE)
1. Fully extend the telescopic
antenna and then press the
FM button to select FM band.
2. Press and hold the FM button,
until the word "PRESET "
starts flashing on screen on
screen and the frequency
starts advancing; now the
radio will start scanning and
storing all the avalible radio
stations into the memory.
When the frequency stops, it
means that the ATS operation
is already done. Then you can
rotate the TUNING KNOB to
search for those stored stations.
MW/LW ATS
:
Press the AM button to select MW/LW band, then follow step 2 of FM ATS.
SW ATS :
Fully extend the telescopic antenna and press the SW ( ) or ( ) buttons to
select SW band.
Modes for SW ATS tuning
A. Using all the meter bands:
Press and hold the ( ) button to ATS the stations within all meter bands.
B. Using the present meter band:
Press and hold the ( ) button to ATS the stations within present meter band.
Notes:
• During ATS process in FM, MW / LW or SW (mode A), pre-stored radio stations will
be replaced automatically by the new searched stations.
• With ATS in SW (mode B), those existing memories will not be replaced; all the
newly found radio stations will be stored in the blank memory addresses.
• If there is too much interference in your surrounding or many mirror/blank stations
are being stored during ATS, you should contract the telescopic antenna (FM and
SW) or rotate the radio for better reception (MW and LW).
USING THE STORED STATIONS
METHOD 2: STORING STATIONS MANUALLY
1. Select band and tune to your desired station.
2. Press the M button with the word "PRESET " flashing.
Press the M button again to store the station into memory.
3.
Note that you can also wait for 3 seconds to auto store the station into memory.
METHOD 3: SEMI-AUTO STORING STATIONS
While operating the Auto Browse Station function, you can simply press on the M
button to store the station into memory to avoid storing unwanted stations and
interfering signals.
Press the VF button to switch into frequency mode.
1.
2. Press and hold the VF button until "
se from one station to another.
While tuning to your desired station, press the M button followed by "PRESET "
3.
flashing to directly store the station into the next available memory.
The unit will keep on browsing until you deactivate it by pressing on the VF
button again.

LISTENING TO STORED STATIONS

METHOD 1: MANUAL MEMORY TUNING
Press the VM button to enter the
memory mode, the word "PRESET "
will appear on the screen. Then
rotate the TUNING KNOB to scroll
through the stored stations one
by one.
METHOD 2: AUTO BROWSE MEMORY
Press the VM button followed
1.
by "memory page" that
appears in the upper right
corner to enter the memory
mode.
2. Press and hold the VM button
until "PRESET " flashes to
automatically scan from one
memory to another,
remaining on each station
for approximately 5 seconds.
To stop the automatic search
memory, simply press the VM
button.
" advancing on the screen to auto brow-
15