Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Unit fails to steam. Lighted
On/Off Switch does not
illuminate.
Unit fails to steam. Lighted
On/Off Switch does
illuminate.
Excessive gurgling in Steam
Hose and Steam Nozzle /
water drips from Steam
Nozzle.
Steam output is weak or
intermittent.
For problems with your Fabric Steamer, please refer to the troubleshooting solutions located
abovel. Additional inquiries should be directed to our Customer Support services through our
Web site, www.topinnovations.com, on the Service Request Web page.
If you do not have internet access, you may also contact our Customer Support Department
by telephone, at (800) 711-6617 or (816) 584-9700.
NOTE: In order for our customer service representatives to help you as quickly and
efficiently as possible, please have the following information ready before calling:
• Purchase information (where and when you purchased this product)
• Product Serial Number
14
T
ROUBLESHOOTING
POSSIBLE CAUSE
Unit is not plugged in.
Household Circuit Breaker /
Ground Fault Interrupter has
tripped or blown a fuse.
Water Tank is empty.
Mineral build-up in unit.
Condensation in Steam Hose.
Mineral build-up in unit.
CUSTOMER SUPPORT
Top Innovations, Inc.
& C
S
USTOMER
SOLUTION
Plug into electrical
outlet.
Reset Circuit Breaker /
Ground Fault Interrupter, or
replace fuse. If you need
assistance, contact a licensed
electrician.
Refill Water Tank using
procedures on page 10 of this
manual.
Follow Removing Mineral
Build-Up procedure on page
13 of this manual.
Some gurgling is a natural
effect of steaming process.
For excessive gurgling or
dripping water, point Steam
Nozzle towards ground and
shake to remove excess water
droplets.
Follow Removing Mineral
Build-Up procedure on page
13 of this manual.
UPPORT
Publicidad
Tabla de contenido
