Publicidad
SETUP AND OPERATION
1.
Place the 1 CHANNEL DMX SWITCH device on a fl at, stable surface. Connect the power supply
using the Power Input (1). Make sure that the power cable supports the power of the/s machine/s
of FX you want to control.
2.
Make sure that the power switch (7) is in OFF position.
3.
Connect the DMX cable to the DMX IN connector (4). You can use either of the 3-pin or 5-pin DMX
IN connectors according to your needs.
4.
You can connect other machines and DMX devices using the DMX OUT connector (5).
5.
Connect the machines to which you want to control the "POWER OUT"(3). The 1 CHANNEL DMX
SWITCH supports up to 20A resistive load, or 15A inductive load.
6.
Switch on (7) the device 1 CHANNEL DMX SWITCH.
7.
If the 1 CHANNEL DMX SWITCH PACK is receiving DMX signal, the led on "SIGNAL" (9) will light up.
8.
Assign the OPERATING DMX channel (13) using the buttons "UP" and "DOWN". Make sure that
the channel selected is free.
SAFETY CHANNEL
9.
The 1 CHANNEL DMX SWITCH is equipped with a safety channel (10) that protects the operating
channel against any unintended activation. Assign the channel you want to use as the safety
channel by using the "UP" and "DOWN" buttons on the safety channel. Make sure that the
channel selected is free. The operating channel is subject to the permission of the safety channel.
10. To unlock the safety channel, your DMX controller must send a value between 40% and 60% to
the security channel. When the safety channel is unlocked, the "ARMED" (12) led will light on and
the operating channel is ready to be activated.
11. After activating the desired channel, you should enable again the safety mode by sending to the
safety channel a value outside of the 40-60%.
12. The 1 CHANNEL DMX SWITCH also allows you to work without safety channel. To disable this
safety channel, simply press the "ENABLE / DISABLE" button (11) to disable position. The screen
of the safety channel will display "DIS" and the led "ARMED"(12) will be lit permanently. To re-
enable the security channel press again the button "ENABLE / DISABLE".
1.
Coloque el 1 CHANNEL DMX SWITCH en una superfi cie llana y estable. Conecte la alimentación
de corriente mediante el conector powercon de entrada (1). Asegúrese de que el cable de
alimentación admite la potencia de la/s máquina/s de FX que quiere controlar.
2.
Asegúrese de que el interruptor de encendido (7) está en posición OFF.
3.
Conecte el cable DMX a la toma de entrada DMX "DMX IN" (4). Para su comodidad dispone de una
toma DMX de 3 pin y otra de 5 pin.
4.
Puede conectar otras máquinas y dispositivos DMX utilizando la toma de salida DMX "DMX OUT"
(5).
5.
Conecte la/s máquina/s que desea controlar a la toma "POWER OUT"(3). El 1 CHANNEL DMX
SWITCH soporta hasta 20A de carga resistiva o 15A de carga inductiva.
6.
Encienda el dispositivo 1 CHANNEL DMX SWITCH (7).
7.
Si el 1 CHANNEL DMX SWITCH PACK está recibiendo señal DMX se encenderá el led "SIGNAL"(9).
8.
Asigne el canal DMX operativo (13) mediante los botones "UP" y "DOWN". Asegúrese de que el
canal seleccionados esté libre.
INSTRUCTION MANUAL
1 CHANNEL DMX SWITCH
/ MONTAJE Y OPERATIVA
Publicidad
