18. Stand the previous assembly upright.
19. With the pilot holes as a guide, pick up the Door Panel (M) and fasten two Hinge Bases (8) to Left Side
Panel (J), using four 15 mm Screws (9) per hinge.
20. Open and close the door to make sure they are aligned and shut correctly. If necessary, adjust the screws for
a good fit. Refer to the hinge sticker on door for adjustment.
21. Stick the Rubber Bumpers (5) on the outer corners of Door (M) where they meet with Right Side Panel (K).
Assembly Instructions
M
J
9
M
J
1
Rubber Bumper
(2 used in this step)
⑤
J
M
5
M3.5 x 15 mm Zinc Screw
(8 used in this step)
15
K
M
5
⑨