Publicidad
Idiomas disponibles
Idiomas disponibles
5
Prepare Camera Mounting Location
! Installation in a covered area is recommended.
! Consult the NEC and local electrical codes for information
on electrical requirements.
a. Before permanent installation, verify wireless Camera opera-
tion using your Nexia account.
b. Attach the base to the wall with three (3) screws and wall
anchors (included). Make certain that the base is secure
on the wall.
c. Attach the power adapter to AC power outlet.
The power adapter is not rated for exposure to moisture.
If the power adapter is located outdoors, follow these impor-
tant steps:
• Attach the power adapter to a covered outlet (shown, not
included), making sure the adapter plug is completely
covered.
• If the extension cable connector may be exposed to
moisture, place it in a covered location, or use a silicone
sealant or a water-tight cord connector (shown, not
included) to protect the cable joint from moisture.
6
Attach Camera to Stand
a. Turn Camera clockwise to attach threaded mount on back of
Camera to the swivel connector.
b. Attach the AC power cable to the power port on the Camera.
Secure the water seal.
c. If the Camera is connected to a wireless network, then install
the water sealing cap over the Camera's ethernet port.
7
Test the camera view using your Nexia Account.
If necessary, loosen the knob on the swivel connector and adjust the camera angle.
Product Specifi cations
Lens: Board Mount Type, Fixed-Focal, Aperture F2.0
Range: 15.25 meters (50 feet)
Night Vision: IR LED x 8, Light Sensor x 1, Auto IR CUT Switcher,Range: Above
5 meters
Minimum Illumination: 0 Lux (with IR LED)
Connectors: RJ45 for Ethernet, DC Power Jack
Power Consumption: 12V DC, Max 4.8W
Compliance: CE, FCC, Power supply: UL
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modifi cations to this equipment not expressly approved by the Schlage Lock Company could void the user's authority to operate the equipment.
FCC ID: P2GBE369
IC: 7654A-BE369
U.S.A. /Canada
(877) 288-7707
nexiahome.com
Base
Covered Outlet
Dimensions (H x W x D): 103 x 94 x 37 mm (4.1" x 3.7" x 1.5")
Weight: 900g (2 lbs)
Operating Temperature: -10°–45°C (14°–113°F); Humidity: 10%–80%
(non-condensing)
Storage Temperature: -20°–70°C (-4°–158°F); Humidity: 10%–90%
(non-condensing)
Ethernet: 10/100 Base-T, Auto MDIX
Wireless: IEEE802.11b/g/n, WEP64/128 bit, WPA/WPA2 Personal, WPS
Wall anchors (3)
Water-tight cord connector
© 2012 Ingersoll Rand
24129744 Online Rev. 08/12-b
Publicidad
