Publicidad
Enlaces rápidos
DuroZone
INSTALLATION INSTRUCTIONS
RD SERIES ROUND DAMPER
INSTALLATION
In flexible round duct
Slip the duct over the
ends of the DuroZone
section and strap it into
place.
MOTOR TERMINALS
1. Trim 1/4" off the end of the Control Wiring.
2. Loosen the screw on the Damper Motor
Terminal Strip.
3. Insert the trimmed Control Wire.
4. Tighten the screw down.
With Part#
35234/35235/35226
35227/35228/35229
®
In rigid round duct
Slip the duct over the
DuroZone section and
screw it into place.
MOTOR TERMINAL IDENTIFICATION
Terminals 1 & 2: 24 volt input.
Terminals 4 & 2: Thermostat Connections - Closing 4 & 2 will
open the damper. Opening 4 & 2 will close the damper.
Terminal 3: End switch - Connecting an equipment relay across 1 & 3
of the damper motor will activate the relay when the damper is open.
LED Indicator
Bi-Color LED indicates Red when damper is closed and Green
when damper is open.
THERMOSTAT
R
W
W
R
Y
1
2
4
6
SMZ PANEL
DUROZONE
MOTOR
TERMINALS
3 4 2 1
Y
Publicidad
Manuales relacionados para DuroZone RD Serie
Resumen de contenidos para DuroZone RD Serie
- Página 1 In rigid round duct In flexible round duct Slip the duct over the Slip the duct over the DuroZone section and ends of the DuroZone screw it into place. section and strap it into place. MOTOR TERMINALS MOTOR TERMINAL IDENTIFICATION 1.
- Página 2 Wire R on the thermostat to damper terminal #2. TYPICAL WIRING When meter measures 24 VAC in reference to (M1) common, wire FOR DUROZONE DAMPERS that transformer output to DuroZone TRANSFORMER TO NON DUROZONE ZONING PANELS Damper Terminal #2. 24 VAC...
- Página 3 ∇ ∇...