Publicidad
Idiomas disponibles
Idiomas disponibles
TH001_ManualENSPFR_021109.qxp
2/11/2009
GENERAL SAFETY WARNINGS AND INSTRUCTIONS
SAFETY GUIDELINES AND DEFINITIONS
DANGER:
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
CAUTION:
Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, may
result in property damage.
RISK OF UNSAFE OPERATION.
When using tools or equipment, basic safety precautions should always be
followed to reduce the risk of personal injury. Improper operation, maintenance or modification of tools or equipment
could result in serious injury and property damage. There are certain applications for which tools and equipment
are designed. Manufacturer strongly recommends that this product NOT be modified and/or used for any application
other than for which it was designed.
READ ALL INSTRUCTIONS
WARNING:
Read all instructions before operating your inverter power switch. Failure to follow all instructions
may result in electric shock, fire and/or serious injury.
• AVOID DANGEROUS ENVIRONMENTS.
Don't use inverter power switch in damp or wet locations.
• KEEP CHILDREN AWAY.
Keep away from children. This is not a toy!
• STORE INDOORS.
When not in use, inverter power switch should be stored indoors in dry, and high or locked-
up places – out of reach of children.
• DON'T ABUSE CORD.
Never carry inverter power switch by cord or yank the cord to disconnect from receptacle.
Keep cord from heat, oil, and sharp edges.
• USE OF ACCESSORIES AND ATTACHMENTS.
manufacturer for use with this inverter power switch could be hazardous.
• CHECK FOR DAMAGED PARTS.
Any part that is damaged should be properly repaired or replaced by an
authorized service center unless otherwise indicated elsewhere in this instruction manual before further use. Do
not use inverter power switch if switch does not turn it on and off.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
This product or its power cord may contain lead, a chemical known to the State of California to
cause cancer and birth defect or other reproductive harm. Wash hands after handling.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK:
• NEVER immerse the inverter power switch in water or any other liquid, or use when wet.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
• DO NOT attempt to connect or set up the inverter power switch or its components while operating your vehicle.
Not paying attention to the road may result in a serious accident.
• Do not open the inverter power switch — there are no user-serviceable parts inside. Opening the inverter power
switch will void manufacturer's warranty.
• Install and operate unit only as described in this Instruction Manual.
• Check inverter power switch periodically for wear and tear. Return to manufacturer for replacement of worn or
defective parts immediately.
• This inverter power switch was designed to operate with Thor Inverters (models TH1000, TH2000 and TH3000)
only. Use with any equipment or appliance not recommended by manufactuer may result in damage to the
power inverter switch and/or the unaithorized equipment; and will void manufacturer's warranty.
Read And Understand This Instruction Manual Before Using This Inverter.
SAVE THESE INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF INJURY:
THE INVERTER MANUAL.
INTRODUCTION
Thank you for purchasing this
THOR Inverter Power Switch.
use to ensure optimum performance and to avoid damage to this product.
7:42 PM
Page 2
The use of any accessory or attachment not recommended by
FOLLOW THESE INSTRUCTIONS AND THOSE FOUND IN
Please read this Instruction Manual carefully before
2
FEATURES
On the front panel are two LED indicators. The green LED indicates power and proper operation of the inverter
power switch; the red LED indicates inverter shutdown from over-load or over-temperature condition, or abnormal
input voltages. The electronic pushbutton turns the inverter ON and OFF. The pushbutton can also be used to force
reset of inverter circuits by switching it off, then back on again if the Inverter Reset Pushbutton does not reset the
unit. This unit also feature a 20' cord with telephone-type connector and a mountable switch plate.
OPERATING INSTRUCTIONS
1. The inverter power switch may be mounted for convenience. Position the switch, following the recommendations
in the Safety Warnings and Instructions at the front of this manual.
2. Plug the invertor power switch cord into the inverter's Remote Control Connection Port.
3. Operate the inverter as usual.
The electronic pushbutton and Power/Fault LED Indicators function exactly as they do on the inverter. Refer to your
inverter manual for detailed operating information, load recommendations and specifications.
Note:
The inverter's On/Off Switch must be in the off position before connecting the Remote Switch and remain in the off position.
All on/off function should be controlled by the Remote Switch.
CAUTION:
Make sure to ALWAYS turn the inverter off using the Remote Switch before disconnecting the unit
from the inverter. Failure to do so will disable use of the inverter power switch's on/off function.
Accessories
If you need assistance regarding accessories, please call: 1-866-955-THOR or visit www.thorpowerproducts.com.
WARNING:
The use of any accessory not recommended for use with this tool could be hazardous and will void
manufacturer's warranty.
Service Information
To locate your nearest service location or for details on replacement parts, contact the manufacturer at 1-866-955-
THOR.
FULL TWO-YEAR HOME USE WARRANTY
THOR Manufacturing warrants this product for two years against any defects in material or workmanship. The
defective product will be replaced or repaired at no charge in either of two ways.
The first option, which will provide an exchange only, is to return the product to the retailer from whom it was
purchased (provided that the store is a participating retailer). Returns should be made within the time period after the
sale of the retailer's usual policy for exchanges. Proof of purchase may be required. Please consult with the retailer
for their specific policy regarding returns that are beyond the time set for exchanges.
WARRANTY ACTIVATION:
Please complete the Warranty Activation Card and mail to THOR Manufacturing. Enter
the model number and product type. All THOR Manufacturing products must be registered within 30 days of purchase
to activate this warranty. Mail the completed registration form, along with a copy of the original sales receipt to: THOR
Manufacturing, 7040 W. Palmetto Park Rd., Suite 4, Boca Raton, FL 33433.
This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other
rights which vary from state to state or province to province. Should you have any questions, contact THOR
Manufacturing at 1-866-955-THOR. This product is not intended for commercial use.
3
Publicidad
