Manual Override - Honeywell evotouch Manual Del Usuario

Manual override

The standby display shows the measured temperature from
evotouch's internal sensor, and the date and time:
Either a static or a dynamic screensaver is available.
• Press anywhere on this screen to display the Home Screen.
To override the programmed temperature
The temperature will stay at the value you have set until the start of
the next scheduled period. The time is shown below the measured
temperature; for example: Set until 18:00.
6
To change the override duration
The following screen is displayed:
Press or to adjust
the temperature setting
• Press DONE to confirm.
Once you have created an override you can change or cancel it at
any time by pressing Press to Change on the Home Screen.
Press Press to
Change
Press PERMANENT
to make the override
permanent
Press or to specify
when the override
should end