Professional Series PS-CO208 Manual Del Usuario página 2

USING YOUR CAN OPENER
Remove the unit and blade bracket from the package before the first time use.
1. To attach blade bracket to the can opener, make the key tabs align with the key slots,
push it frontward to fix it (see Fig. 1), then press down the blade bracket to ensure it has
been assembled in place (see Fig. 2). Then lift the blade bracket
2. Connect to the power source.
3. Tip the can so that its rim is under the locating post, the lid of the can will be sucked
by magnet, then press down the blade bracket while the On/Off button to the "On"
position. Make sure the blade is inside the rim (see Fig. 3).
Drive wheel will actuate the can to rotate and the blade will
cut the can lid open. Because of the hands-free feature, it is
not necessary to hold blade bracket
down or support the can during cutting.
NOTE: 1.The can required to be opened shall be 50mm to
100mm in diameter and 178mm max in height. In the case total
weight of can is over 510g, it is necessary to press and hold the
can opener to avoid overturning 2. No more than 5 cans could be open continuously. Every
interval time should 15 seconds. 3. This product is only suitable for circular jar.
The cans opened with this Can Opener must be less than 0.6kg in weight.
4. When the can is opened, the can opener will stop automatically. To remove the can, hold it
with one hand and raise the blade bracket with the other one.
CAUTION: Avoid contacting with the cut edges of the can or lids as they are sharp, carefully
remove the lid from the magnet and discard.
NOTE: The time of opening cans continuously do not exceed 1 minute
(Note: the time is not KB time).
5. The excess cord can be stuffed into cord storage at the back of the unit, and feed the cord
through the notch for convenient storage.
Fig. 1
TO OPEN BOTTLES
Before opening bottles, unplug the power supply firstly.
1. To open a bottle, grasp it and position the cap under the
metal hook part in the bottle opener (see Fig. 4).
NOTE: Be sure the bottle neck is not under the metal hook
part, or the glass may break. Hold the can opener with one
Fig. 2
hand and pull down to pop the cap off with the other one.
2. The bottle opener at the front of the unit will only
remove metal bottle caps. Do not use it for the bottle
with screw-off cap or pull ring.
TO SHARPEN KNIFES
Unplug the power supply firstly, and then place the knife which
is intended to be sharpened in the slot of knife sharpener at the
Fig. 3
back of the unit. For best results, sharpen the entire length
carefully to pull the knife through the slot back and forth
(see Fig. 5), until desired sharpness achieved. After
sharpening, wash and dry the knife. The sharpener also
can be used for sharpening stationery scissor.
NOTE: Be cautious with knife after sharpening
KNIFE SHARPENING TIPS
1. Clean and dry knives before sharpening.
2. Do not attempt to sharpen serrated blades,
as this will smooth their edges.
3. Do not attempt to sharpen scissors.
Fig. 4
Fig. 5