EAS ELECTRIC WFLC191 Manual De Instrucciones página 39

 Connect the male joint of the connective wires group-1
to the mainboard，then connect the other side of the
connective wires group-1 to the 4-cor e shielding wire
of the smart port. (See Fig.4-3)
If want to extent the wire, please use extension cord

(purchased separately). (See Fig.4-3)
4.4 Remove the upper part of the smart port
Insert a slot screwdriver into

the slots in the lower part of
the smart port (2 places), and
remove the upper part of the
smart port. (Fig.4-4)
4.5 Fasten the back plate of the smart port
 For exposed mounting, fasten the back plate on the
wall with the 3 screws (M4×20) and plugs. (Fig.4-5)
Back plate
Screws (M4×20)
Fig 4-5
7
Slots
Fig 4-4
V.1