Lubrication - Husqvarna Z 254F Manual Del Operador

LUBRICATION

12/12 Every year
1/52 Every Week
1/365 Every day
General
Remove the ignition key to prevent unintentional
movements during lubrication.
When lubricating with an oil can, it must be filled
with engine oil.
When lubricating with grease, unless otherwise
stated, use a high grade molybdenum disulphide
grease.
For daily use, the machine must be lubricated
twice weekly.
Clean away unwanted grease after lubrication.
It is important to avoid getting lubricant on the
belts or the drive surfaces of the belt pulleys.
If this happens, try to clean them with spirits. If
the belt continues to slip after cleaning, the belt
must be replaced. Gasoline or other petroleum
products must not be used to clean belts.
26
Lubricate with grease gun
Filter change
Oil change
Level check
IMPORTANT INFORMATION Use minimal
lubrication and remove excess lubricant so that
is does not come into contact with belts or belt
pulley drive surfaces.
WARNING! Escaping hydraulic oil under
pressure can have sufficient force to penetrate
the skin, causing dangerous injury. If injured
by escaping fluid, see a doctor immediately.
Dangerous infection or reaction can develop if
proper medical treatment is not administered.