Assembly And Adjustment - DeWalt DC509 Manual De Instrucciones

E N G L I S H
DO NOT let children come into contact with
the tool. Supervision is required when
inexperienced operators use this tool.
1 On/off switch
2 Base
3 Flexible tube
4 Head
5 Lens
6 Lens holder
7 Battery pack (not included)
Electrical safety
Always check that the battery pack power
corresponds to the voltage on the rating
plate. Also make sure that the voltage of
your charger corresponds to that of your
mains.

ASSEMBLY AND ADJUSTMENT

WARNING:
• Prior to assembly and
adjustment, always remove the
battery pack.
• Always switch off the tool before
inserting or removing the battery
pack.
• Before using the tool, make
sure the battery pack is properly
seated.
Battery pack (fi g. B)
Battery type
The tool will operate on battery packs
of 36V or 28V. Refer to the table near
the end of this section for a selection of
applicable battery packs.
WARNING: Use only D
battery packs and chargers.
Fitting and removing the battery pack
Make sure the battery pack is properly
seated.
• To fi t the battery pack (7), line it up with
the receptacle on the tool. Slide the
16
battery pack into the receptacle and
push until the battery snaps into place.
• To remove the battery pack, push the
release button (8) while at the same
time pulling the battery pack out of the
receptacle.
Battery pack condition
• Make sure your battery pack is (fully)
charged. If the battery pack does not
produce suffi cient power, charge the
battery pack following the instructions in
the manual of the charger.
Replacing the light bulb (fi g. C)
• Unscrew the lens holder (6) and
remove it.
• Simply pull out the bulb (9) and insert a
new one.
• Reinstall the lens holder (6).
Positioning the head (fi g. D)
Your fl ashlight can be used as a standing
model or as a handheld model. When
used as a handheld model, the tool can
be carried at the fl exible tube. When used
as a standing model, the head can be
positioned by means of the fl exible tube to
adjust the direction of the beam of light.
• Hold the base (2) with one hand and
with the other hand slide the head (4)
off the base.
• Mould the tube (3) as necessary position
the head.
• To refi t the head, hold the head in front
of the base and slide the head on until it
clicks into place.
OPERATION
Instructions for use
WALT
E
Switching on and off (fi g. A)
• To switch the tool on, slide the on/off
switch (1) to the left.
WARNING: Always observe the
safety instructions and applicable
regulations.