Binzel Abicor PP Instructivo De Servicio página 24

4 Putting into operation
4.1.2 Liner (plastic)
1
10
9
8
1 Wire conduit
2 Central connector
3 Nut
4 Wire feed rolls
Fig. 3 Shortening the PA liner
EN - 8
1 Lay down the cable assembly (9) straight and unscrew nut (6) from central
connector (4).
2 Slide the liner (8) through the wire conduit (3) until a noticeable resistance
is felt in the inlet nipple (2).
3 Determine excess length x and pull out the liner (8) again.
4 Shorten the liner (8) by the dimension x.
5 Debur the cutting point and sharpen the spiral beginning to an angle
of 40°.
6 Insert the liner cut to length (8) into the wire conduit (3).
7 Screw down nut (6) and secure with multiple wrench (5).
For use with aluminium, copper, nickel and stainless steels
40°
7
5 ABICOR BINZEL Cutter
6 O-ring
7 Clamp nipple
1 Lay down the cable assembly straight and unscrew nut from central
connector (2).
2 Sharpen the beginning of the PA liner (8) to approx. 40° using the
ABICOR BINZEL sharpener (9).
3 Slide PA liner (8) through the wire conduit (1) into the inlet nipple (10) until
a noticeable resistance is felt.
4 Slide clamp nipple (7), O-ring (6) and nut (3) on the PA liner (8) and
tighten the nut (3) under tension.
5 Mark a PA liner (8) that is too long in front of the wire feed rolls (4) (wire
feeder).
6 Cut the PA liner (8) at the mark directly in front of the wire feed rolls using
the ABICOR BINZEL cutter (5) .
7 Sharpen the cutting point.
2
6
8
9 ABICOR BINZEL
10 Inlet nipple
3
4
5
Liner (plastic)
Sharpener
PP