HR Matic HR RE433V1 Guia De Inicio Rapido página 3

1
DESCRIPTION
Miniaturize receiver Rolling Code, 1 channel with dry contact relay output 1A a 30 Vdc / 0.5A a 42.4 Vac.
Power supply 12-24 Vac/dc, frequency 433.92Mhz.
SignalingLED
Learning bu! on
Selector for power
supply
2
LEARNING OF TRANSMITTERS
1. Select the power supply with the jumper and power up the receiver.
2. Press the learning bu! on. The LED will light up.
3. Press the bu! on of the transmi! er you want to memorize. The LED will blink 2 " mes for the correct learning.
Repeat the procedure to memorize other transmi! ers.
The receiver memorize only one bu! on for every transmi! er. In case of learning of a second bu! on of the same
transmi! er, the receiver will remove the fi rst bu! on learnt.
3
MODALITY AND SELECTION OF THE FUNCTIONING
The func" oning modali" es of the relay are two::
1. IMMEDIATE: the relay is ac" ve as long as the radio signal is it as well, and the relay output is closed as long
the transmi! er bu! on is pressed.
2. ON TIME: the relay, once ac" vated, is ac" ve for a programmable " me from 1 seconds up to 60 seconds.
In order of selec" ng the required func" oning modality, proceed as follow:
1. Press and keep pressed the learning bu! on for more than 10 seconds.
2. When the LED blinks fast, it is possible to release the bu! on. In this moment the " me is set to 0 seconds
(immediate func" oning).
3. Press and release the learning bu! on to increase the " me of ac" va" on of the relay. Each " me you press
and subsequent release, the LED blinks one " me and the " me is increased by 1 second, un" l a maximum
of 60 seconds.
4. Press and keep pressed the learning bu! on for more than 5 seconds.
5. When the LED blinks, it is possible to release the bu! on. The " me has been memorized.
During phase 3, a• er 20 seconds of inac• vity, the receiver exits from the func• on, by • meout, without
saving se• ngs and it will be set the immediate func• oning.
6-1620065 rev0
HR RE433V1
Antenna
Radio module
12-24
Vac/dc
ITA ENG
02/07/2015
Code
Max transmi! ers
Power supply
Consump" on
Channels
Frequency
Unobstructed range
Relay contact
Temperature
*The range is infl uenced by the type of transmi! er, antenna and
radio interferences
FRA ESP DEU POR
Rolling Code
1000
12-24 Vac/dc
45mA dc - 85mA ac @12V
50mA dc - 100mA ac @24V
1 (immediate or on " me)
433.92 MHz
80-250 m*
1A a 30 Vdc / 0.5A a 42.4 Vac
-10...55°C
3/8