HyLoft 50175-10 Instrucciones De Ensamblaje página 3

Installation Time: Approximately 30 minutes
Important: Read through entire instructions before beginning any installations.
Locate the ceiling joists int he area of desired installation and determine the direction in which they
are running. The ceiling mounting plates on Downrods (B) are installed parallel to the ceiling joists.
Refer to the diagram below for additional installation clarification.
IMPORTANT: Do not over-tighten the Lag Screws (max 10 ft. lbs.).
They only need to be fully seated, no more. Do not use an impact driver.
1. Install Downrods
1A:
Place Downrod (B) against ceiling under joist location and mark holes running parallel with
the joist. Pre-drill each hole location using a 3/16" drill bit. Rub bar soap or add a drop of
liquid soap to the threads of the Lag Screws (E) to ease installation. Install Downrod (B) using
1/2" Socket Wrench or Nut Driver and (2) 5/16" x 2-1/2" Lag Screws (E).
1B:
From the outside edge of the Downrod (B) footplate just installed, measure 68-1/2" along
ceiling joist and mark this location. This mark will be the OUTSIDE edge of the second
Downrod (B). Install second Downrod (B) using the same process as in 1A and make
sure it lines up with the first Downrod (B) installed on the joist.
2. Install Corner Rods & Support Bars
2A:
Attach (2) Corner Rods (C) to each of the
Support Bars (D) using (4) 1/4" x 1-1/2"
Hex Bolts (I) and (4) 1/4" Flanged Nuts (K).
2B:
Determine the length down from the
ceiling you want the unit to hang (from
31" to 41"). Attach the Corner Rod (B)
and Support Bar (C) assembly to each
Downrod (B) at the predetermined
length using (2) 1/4" x 1-1/2" Hex
Bolts (I) and (2) 1/4" Flanged Nuts (K)
for each. Repeat for the other set of
Downrods (B). Ensure both assemblies
are parallel and in line to each other.
Page 3
Using a
stud-finder
locate any
2 Joists
24" to 32"
apart
Outside edge of
downrod footplates
must measure exactly
68-1/2" apart.
I
C
D
I
I