HAMPTON BAY 91169 Guía De Uso Y Cuidado página 5

Optional Installation - Installing the Light Kit to the Altura Fan
1
Preparing the fan
□
Remove the ceiling fan switch cup (E) from the switch cup
adaptor (H) by loosening the two screws located in the "L
shaped" slots and removing the mounting screw in the non-
slotted hole (UU).
□
Twist the switch cup counter-clockwise to remove it from
the switch cup adaptor (H).
□
Disconnect the 9 pin connector by pressing the tab (MM)
and gently pulling the ends apart (you may need to use a
small flat screwdriver to gently lift the tab (MM) over the
lock).
MM
3
Wiring the light kit to the fan
□
Remove the lockwasher (HH) and hex nut (II) from the
threaded nipple of the light kit fitter assembly (A) and save
them for later use.
□
Insert the black wire and the white wire from the light kit
through the center hole of the switch cup (E) one at a time.
□
Slide the ceiling fan switch cup (E) onto the threaded nipple
on the top of the light kit (A).
□
Insert the black wire and white wire through the lockwasher
(HH) and hex nut (II). Tighten them securely.
UU
MM
H
E
2
Removing the receiver from the
switch cup
□
Remove the two screws (KK save for later use) that hold the
receiver (NN) in place, and lift the receiver (NN) out of the
switch cup (E).
□
Hold the threaded retaining nut (JJ) with one hand and turn
the bottom cover (GG) counterclockwise with the other.
□
Remove the threaded retaining nut (JJ) from the switch cup
(E) and reattach it to the bottom cover (GG) (save).
NN
JJ
5
Please contact 1-855-HD-HAMPTON for further assistance.
KK
GG
HAMPTONBAY.COM
E
GG & JJ
(save)
LL
E
II
HH
A