Adjustment Instructions - Holmes HCF0611A Guia Del Propietario

F E AT U R E S - O P E R AT I O N S
ASSEMBLY INSTRUCTIONS (SEE FIGURE 1)
Your Personal Fan comes with the assembled fan head, a
pole with clip, Tilt adjustment knob screw/nut and an
optional removable base. Carefully unpack your fan,
insert the fan head into the pole and secure with the
provided tilt adjustment knob/screw and nut (see Figure
1).
CONVERTING TO DESK FAN
To convert to a desk fan, simply clip the fan onto the
provided base (see Figure 1), and use the fan on a dry
and level surface.
Figure 1
B
C
D
E
G
H
A. Fan Head
B. Carry Handle
C. Motor Housing
D. Speed Control Knob
E. Securing Nut
F. Tilt Adjustment
Knob/Screw
A
F
I
J
G. Pole
H. Clip
I. Base (Optional -
Desk Fan only)
J. Rubber Grips
OPERATING INSTRUCTIONS
1. Clip fan onto a dry, solid surface.
2. Plug cord into any standard 120 volt AC outlet.
Please make sure the speed control is in the OFF (0)
position.
3. The speed control knob is located at the back of the
Fan Motor Housing. The speed is adjusted by turning
the control knob to the desired setting, Off-Low-High
(0-1-2).
WARNING: Do not clip this fan to any delicate surface
as this may leave a permanent mark. Also, to reduce the
risk of the fan tipping over, avoid clipping to surfaces
that cannot be firmly and fully gripped. It is
recommended to clip the fan on flat surface with 5-25
mm thickness.

ADJUSTMENT INSTRUCTIONS

Vertical Angle Adjustment
1. To change the tilting angle of the fan head, simply
loosen the tilt adjustment knob.
2. Move the fan head to the desired angle, then firmly
tighten the knob to lock the fan head in place.
WARNING: MAKE SURE TO SUPPORT THE FAN HEAD
ASSEMBLY WHEN LOOSENING THE TILT ADJUSTMENT
KNOB, AS THE WEIGHT OF THE FAN HEAD MAY CAUSE
THE POLE TO COLLAPSE.
Horizontal Adjustment
Turn the fan head to the desired direction.