Publicidad
2
Wall Mounting
2-1: Wood Stud Mounting
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:
Pilot holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.) diameter drill bit.
Do not over-tighten the lag bolts [08].
Any material covering the wall must not exceed 16 mm (5/8 in.).
2-2: Solid concrete and Concrete Block Mounting
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:
Pilot holes MUST be drilled to a depth of 75 mm (3 in.), using a 10 mm (3/8 in.) diameter drill bit.
Be sure the anchors [10] seat fl ush with the concrete surface.
Mount wall plate directly onto the concrete surface.
Never drill into the mortar between blocks.
Do not over-tighten the lag bolts [08].
NOTE: Mount will shift 3.72" (94.5 mm) in either direction
from the center when in the home position. Consider this
when selecting the location of your wall mount.
12
3.72"
94.5mm
CAUTION:
3.72"
94.5mm
3.72"
3.72"
94.5mm
94.5mm
6903-002002 <01>
Publicidad
